Dust Collection Duct Wall & Ceiling Mount – Fully Parametric
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This a parametric model for a bracket to mount dust collection ducting.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 57
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Garage
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This fully parametric wall and ceiling mount system was designed in Autodesk Fusion. This modle was tested with 5", 6", or 7" duct. You can try other sizes or adjust fit as you need.
Wall Mount The wall bracket is built around M5 x 25mm cap head bolts and M5 nuts for a solid, rattle-free clamp. For mounting to a board, it uses M5 T-nuts for a clean, recessed fastener that won't back out over time.
Ceiling Mount The ceiling version uses an M10 threaded insert pressed into the print, paired with standard M10 threaded rod. This lets you set the drop height exactly where you need it.
Parametric Design The model was designed from the ground up to be parametric in Fusion, so resizing for different duct diameters is straightforward. The default model is sized for 5" duct, but 6" and 7" variants have been tested and work great.
Hardware List
(4) M5 x 25mm Cap Head bolts
(2) M5 nuts
(2) M5 T-nuts (for board mounting)
(1) M10 threaded insert
(1) M10 threaded rod (cut to desired length)
Print settings
My shop stays relatively cool, so I used basic PLA. The original version of these brackets have been in use for over a year with no issues. PETG would be another good option.
I used 4 Walls and 25% infill.