LCD mount for Raspberry Pi DIN rail case

This is a small bracket that fits in a Raspberry Pi DIN rail mount case available on Aliexpress.

It only fits that Aliexpress case, which is available for Raspberry Pi 3, 4 and 5 (but be sure to order the correct one as each is different to match the Pi's changing port locations).  Have a look at the photos to see what the case looks like, although at the time of writing it's the only one on Aliexpress that's both DIN rail mount and has a transparent faceplate.

It will only fit the 2.2" SPI LCD also available from Aliexpress.  Have a look at the photos to see what the back of the LCD PCB looks like, noticing it says "QVGA 2.2 TFT SPI 240X320" and browse Aliexpress for ones that look the same.  There are many different sizes but this particular 2.2" one is commonly available from multiple sellers.  Note the nine pin connector on one side, the (unused) SD card slot, and that it uses the SPI protocol to receive data from the Pi.

This bracket clips into the existing clips on the case to lock in place, then it has holes for short screws.  I used some very short M2.5 screws designed for screwing into plastic (from a kit off Aliexpress no less), but M2 screws should work fine too, and given how little weight it has to hold, I don't think they particularly need to be plastic screws.  M3 screws might be too large due to the holes in the PCB being so close to the walls of the case, so the head of the screw might contact the case.

The case comes with four small "pins" that need to be snipped off with side cutters in order for the bracket to fit - see the photo with the blue side cutters.

I printed it in PLA but any material should be fine, as long as it's soft enough for the screws to go into.

This is my first 3D printable model so it may not be perfect :)