1 / 2
3-1/2 and 4" hinge door jamb router mortise template rounded and square — zdjęcie 1
1 / 2

3-1/2 and 4" hinge door jamb router mortise template rounded and square

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Clamp on router template for mortising hinges into doors or jambs

Ocena
0 / 5
Polubienia
7
Pobrania
64
Wydruki
0
Wyświetlenia
238
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Noncommercial

Updated 4/20/2026: I needed two different size templates for two different thickness hinges so I combined both into one for square hinges. For the corner, leave the hinge template on after routing and then knock the corner out with a chisel.

After realizing the mortise template I bought online only works on the door, not the jamb I quickly designed this so I could get my doors hung in the house. It is for a 3-1/2" hinge with 5/8 radius corners, set back 1-3/16 from the edge. You'll need a 1/2" dia x 1/2" deep mortise routing bit (has the bearing on the shank side).  

I have also included a pocket to set the depth of the mortise routing bit calibrated to mortise 1/8" deep. Just set the bit in the router, put the bit in the hole and set the plate depth on the router to the face of the template.

You could easily modify it to move the setback to whatever you need. It just involves modifying the "bar" stop that rests against the frame. You could also use this for square hinges - just use a corner knock-out and/or chisel the corner out by hand once you cut the mortise. 

There are 4 screw holes. The two on top are suitable for use on the door jamb if you don't have the stop installed already. No need to putty the holes after routing since the holes will be covered by the stop. I'm only working on new construction, so I just made a version that doesn't need a cutout to ride over the door stop. 

You could also use this on a door- I wouldn't use screw holes, but just use a small clamp to hold it in place.