1 / 2
Zugentlastung für Kabel / Strain relief for cables — zdjęcie 1
1 / 2

Zugentlastung für Kabel / Strain relief for cables

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a simple strain relief to avoid accidentally pulling out a cable from the case of some device

Ocena
0 / 5
Polubienia
5
Pobrania
32
Wydruki
0
Wyświetlenia
263
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

DISCLAIMER: I am not to be held responsible for any damage or harm done using this model. Only perform electrical operations in case you know what you are doing.

This is a simple model using only 3 grams of filaments (and no supports needed!) to secure a cable within the wall of some case... Make sure to secure your cable using the clip and two screws.

I have printed this on an Ender 3 V3 SE using PLA, and I myself was way too weak to remove the cable by pulling...

The STL provided as is assumes your cable has a diameter of 7 mm and the wall your device's wall is roughly 2.5 mm thick. However, you can change those values easily just by editing the spreadsheet within the FreeCAD project. I generally recommend setting the diameter of the hole roughly half a milimeter higher than the measured...

Please note I still am a CAD-Noob, so my usage of FreeCAD may have been a little clumsy!

Tagi