Dyson - Laifen Hair Dryer Holder v1.2 (2-Screw Wall Stud Mount)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Get that hair dryer off the counter and stowed neatly on the wall!
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 88
- Wydruki
- 0
- Wyświetlenia
- 318
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a remix, Shoutout to OG creator @DerDerlchBin !!
V1.1
I was about to print this for my wife's hairdryer to get it off the bathroom counter for her – but then I thought to myself — “it could be nice to have mounting holes”.
Since we don't have enough width for spanning two wall studs (14 inches apart here in the Texas part of the world), the design I created is for single stud (just weak drywall mounts are for n00bs, I want to be able to wall climb anything I mount on my drywall, or hang a refrigerator off of it, bare minimum, no less)
-- white strip in image attached represents a 1.5"W wall stud (38.1mm),
two holes 12mm off center ea (24mm center to center holes),
diameter of main hole is 4mm standard for screw shaft,
w/ 7mm diameter for screw head countersinks.
V1.2
came back and modded to push twin holes off center to the right to now be directly beneath hairdryer handle cutout, so that it is easier for a power drill to hit the screw head square on at 90 degrees, rather than angling upward to avoid rubbing the bottom of the scoop.
I could have lowered the preset holes down further to amend this, but I didn't want to forego the additional thickness of material that is found beneath the scoop – and furthermore, this location assists to conceal the screwholes somewhat from an upward PoV, which is particularly nice if you want a diff color filament than the color of screws you have on hand!!
DETAILS! always the details!! you know your wife is going to point it out if you don't think of it beforehand. Gotta think about these things!
You could also print off a couple 3.98mm simple cylinders to act as screwhead caps to assist in concealing the screwholes. I will experiment with this after my printer is free again, if successful, I'll just add a couple simple STLs to make that an easy download addition for y'all.
I will also post some pics once it is on the wall!
Drop a like or comment, and the best of all is when I get to see makes from folks. I'm sure the OG creator will appreciate it as well!