UV resin curing box
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This box is (re)designed to take a 50 watt UV led COB that is powered directly on 220 or 110 volt.
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 69
- Wydruki
- 0
- Wyświetlenia
- 1192
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This box is (re)designed to take a 50 watt UV led COB that is powered directly on 220 or 110 volt.
Print instructions
This box is (re)designed to take a 50 watt UV led COB that is powered directly on 220 or 110 volt. I bolted this onto a "Arctic Alpine 64 GT Rev. 2 – Processor cooler" that I got from amazon. Just drill some 2.5mm holes into the cooler block and wiggle the dril slightly. The you should be able to screw some M3 machine screws straight into the soft aluminium.
In addition to the original I've added a raiser rack that lifts your print off the bottom, this allows the underside to cure properly from the light that is reflected by the aluminium. I suppose time will tell how the thin plastic will hold up to much UV abuse... When it fails I'll just bend a riser from some chicken wire I think.
I covered the inside of the box with some "Aluminium tape" that you can get in any DIY store.
Get the version without a lens or cooling block, just the COB:
https://www.aliexpress.com/item/4000144567253.html
https://www.amazon.de/gp/product/B001A5V1K2
This is a remix of https://www.thingiverse.com/thing:2528201