MONO X VOC FILTERING SYSTEM 80mm Remix
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Anycubic Mono X VOC filtering system
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 30
- Wydruki
- 0
- Wyświetlenia
- 411
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
I have remixed JVJV's Anycubic Mono X VOC filtering system to use an 80mm fan and take up less space behind the printer.
This design should work with most 80mm fans, I am using a silent 12V fan I had lying around (which is quieter than the printer), powered by an old 12v power brick I cut off something.
As recommended by JVJV in his thingiverse post, I have used a HEPA filter and Activated carbon filter both cut to size. The smell while printing is significantly reduced.
I have used PETG as resin will dissolve PLA and I am not sure about the long term effects. Probably wouldnt matter though as the inside would just be chemically smoothed a little over time.
Also, Thanks JVJV for providing the .f3z files.