Nerf Rival Knockout plunger cap
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
After removing the plunger cap on the rival knockout about 15 times the tabs on mine started to wear down so I took to…
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 42
- Wydruki
- 0
- Wyświetlenia
- 357
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial
After removing the plunger cap on the rival knockout about 15 times the tabs on mine started to wear down so I took to fusion to design a new one. If you want this printed message Dart Nerd Customs on Facebook. This is currently untested but it should work.
How I Designed This
Fusion 360
First I created a sketch of the bottom surface with all of the various segments I would need to extrude. I then took height measurements of everything and extruded it
Sketch
Without the clips
then I took some more measurements and designed the clip. Then just a pattern and you are good to go.
Category: Other