AD5M Pro lid riser for filament cutter clearance
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Riser for AD5M Pro for basic tubing & filament cutter clearance
- Ocena
- 5 / 5
- Polubienia
- 6
- Pobrania
- 35
- Wydruki
- 1
- Wyświetlenia
- 259
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
I've redesigned a riser for the AD5M Pro's lid. This helps clear the tubing AND the added height needed for the filament cutter. I also filet'd the inner edges because I realized that reaching in to deal w/ filament change means I sometimes come into contact w/ the edges, so I soften to edges to make it more gentle on the skin
I used a combination of 10x3mm magnets and pegs so the riser can be disassembled when needed but still held together cleanly.
If you want, you can install some tape on felt liner to help seal the lid as well.
I printed mine in PETG. Used superglue to attach the magnets. the rest should fit perfectly.
Support is required because of the overhang. If you're comfortable with your 5M Pro, you can set the slicer so that 1 layer prints the final interface for the support only and pause that layer so you can use PLA as the final support interface layer, then swap it back to PETG to finish the rest of the print (make sure that the PLA layer in the slicer prints the support layer and ONLY the support layer, not the main model's walls. if it's still trying to print the wall and top interface layer, test different layer heights and top Z height so your slicer isolates the top interface layer as its own exclusive layer)
Print settings:
Nozzle: 0.4mm
Print Height: 0.12mm (for the curves)
Material: PETG or any filament that has better temp resistance, but PETG is easy enough.
Supports: Yes (Normal - Snug)
Support Top Z Distance: 0.15
Wall order: Inner/Outer
Walls: 3 (or 2 + alternate walls)
Infill: 8-12% Gyroid or 3D honeycomb (some strength required just in case you flip the lid open a little hard)
Bill of Material:
10x3mm N52 disc magnet x 4: https://a.co/d/0ed5Bag3
Felt tape 25mm wide minimum x 1: https://a.co/d/0djxHesw -> or something like that.
If there is a gap in the back piece, throw on 1 adhesive felt strip to seal it up.