Kossel Mini Top Vertex Idler Tensioner
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I find the slanted screw on the original a little awkward so I repositioned the tensioning screw to push down…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 223
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
I find the slanted screw on the original a little awkward so I repositioned the tensioning screw to push down vertically on the tower extrusion.
Adds about 16mm height to the original.
OpenSCAD file included but you have to get the other support files from Johann's github repository - https://github.com/jcrocholl/kossel
Instructions
Important:
Insert a small nail to with a head big enough cover the center hole in the aluminum extrusion profile. This will serve as the pressure point that is pushed by the tensioning screw. I used the pin pushed out from a blind rivet. It's got a nice round head that fits the tip of the allen screw perfectly.
Without this cover, the screw will dig into the hole.
Place M3 nut underneath the "cap" to pair with the M3x12mm allen cap screw.
Tighten screw to increase tension on the belt.
Category: 3D Printer Parts