Closable aeropress filter holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A little closable cylinder to hold your aeropress filters.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 25
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial
A two piece aeropress filter holder that closes snugly and meshes together. There's a circular cutout on one piece letting you easily take filters out and a matching circular key on the other, so they always close the same way. I've had this both in my kitchen and in by bag and it stayed closed. Fits quite a lot of filters, can't say how much exactly, but one whole package of filters doesn't fill it up half way.
Print one of each part, you can print from whichever plastic you'd like, I printed it out of PETG with a 0.6mm nozzle and 0.18mm layer height, but most any print settings should work. One thing I'd recommend is a small layer height as to have the circular slot and protrusion smoother and let them mesh together better.
The tolerance between the two parts is 0.2mm (or, rather, 0.1mm on each side) so it should allow for most printers to print this out without much tuning.
This print uses a minuscule amount of plastic, I think in total it was 60g for both the top and the bottom.