Arduino Uno Adafruit Motorshield case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A case for the Arduino Uno Adafruit Motorshield unit with motorsport look.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 26
- Wydruki
- 0
- Wyświetlenia
- 130
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
An Arduino Uno Adafruit Motorshield (v2.3) case in the design of a motorsport EMU (Engine Management Unit) for my racing simulation aluminium extrusion rig.
There are two variants, one for the 80mm aluminium extrusion width and one for mounting on flat surfaces.
No support for printing necessary.
Part | Amount | Info |
|---|---|---|
Case(_Flat) | 1 | Two versions are available: |
Plate | 1 | The cover of the Case and the cable guide. |
Fixtureblock | 1 | Keeps the Arduino curcuit board in place. |
M3x10 hexagon socket head screw | 2 | To mount the Plate to the Case. |
M4 flat head screw | 3 | Only necessary when not using the Case_Flat version. |
T-Nut | 3 | Only necessary when not using the Case_Flat version. |
Flat head woodscrew or simila | 3 | Only necessary when using the Case_Flat version. |
Zip Tie with maximum 4.5mm width | 1 | |
Arduino Uno | 1 | |
Adafruit Motorshield | 1 | My shield has the version 2.3. I cannot tell if other variants are compatible. |
Mounting:
Please check the Arduino and Adafruit Motorshield manual in front.
Mount the Case to the surface. In case of aluminum extrusion, apply the T-Nut to the aluminum extrusion and use the M4 flat head screws.
Put the Motorshield on the Arduino Uno.
Pass the motor and power supply single conducters/cables throu the "Plate" on the right opening. It may be helpful to guide them between the two curcuit boards.
Apply all the cables to the terminal clamps of the Motorshield.
Insert the Arduino Motor Shield unit into the Case, with the USB port oriented toward the opening.
Slide the Fixtureblock into the Case.
Guide the USB-B cable through the left side of the opening in the Plate and connect it. The cable can be removed and plugged in later still.
Slide the Plate on the Case and apply the M3x10 hexagon socket head screws.
The plate has on the bottom two cable tie slots which are meant to fixture the cables.
If you have any comments, suggestions or similar, you are welcome to contact me.