Filament holder striped and voron edition
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remixed the base of the spoolholder and added some tools for opening screwhole and socket for screwing the pins in.
- Ocena
- 5 / 5
- Polubienia
- 8
- Pobrania
- 33
- Wydruki
- 1
- Wyświetlenia
- 463
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Share Alike
This is a remix of the base of misterT spoolholder.
Made a striped version and a voron logo based version.
Also added a tool for reaming the holes and a socket tool for screwing in the pins and not damage the base with metal tools. It is as deep as the head of the pin. No need for 18mm wrench.
The reamer is not working as good as I thought it would. This should be printed out of a harder material ideally. The base was PLA+ and the reamer (white) PETG was too soft. Also PLA+ reamer was not holding up as I hoped it would.
First you can use the reamer tool and then go to using a pin. You have to screw the pin in and out a quarter turn and bit by bit turn it in a bit more. Don't go too fast that it heats up and melts together ! Don't go donkey kong on it and break the base.
You can sand down the point of the pin if needed to press fit into the bearing before assembling. Takes some strain of screwing the pin in off.
I used the Prusaslicer modifier to make a solid top of the socket tool and the thread of the reamer and also used the layer tool to make the thread layers 0.10mm and the rest of the print 0.20mm.
Cleaning the thread of the base a bit is also recommended before starting to screw a pin in.