1 / 3
Replacement Rotary Joint for SUNRIMOON SG-01 Bike Phone Holder (90° Limit, Bolt-On) — zdjęcie 1
1 / 3

Replacement Rotary Joint for SUNRIMOON SG-01 Bike Phone Holder (90° Limit, Bolt-On)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This 3D model is designed to replace a damaged rotary joint on the SUNRIMOON SG-01 bike phone holder.

Ocena
0 / 5
Polubienia
1
Pobrania
5
Wydruki
0
Wyświetlenia
70
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Ideas
Licencja
Creative Commons — Attribution

Replacement Rotary Joint for SUNRIMOON SG-01 Bike Phone Holder (90° Limit, Bolt-On)

Description

This 3D model is designed to replace a damaged rotary joint on the SUNRIMOON SG-01 bike phone holder. The damage occurred as a result of a bike fall. This model is also suitable for cases where the limiter is worn out, or where play has developed or the plastic is deformed due to vibration and temperature changes.

What this model does:

Fully restores the functionality of the rotary mechanism between the handlebar mount and the phone holder.

Limits the rotation angle to a precise 90 degrees. The position cannot be changed after installation.

Allows the use of the standard bolts included with the holder—no additional fasteners are required.

Maintains a secure angle even off-road.

Features:

  • Recommended material: PETG or ABS (high impact strength and vibration resistance) / Nylon (for extreme conditions).

  • Rotation angle between stops: limited to 90° (±2° for plastic shrinkage); you can only choose two orientations.

  • Installation Instructions

  • Completely disassemble the damaged SUNRIMOON SG-01 unit, removing any remaining broken original part.

  • Install the 3D printed model in the original mounting location, choosing the desired orientation for the phone.

  • Tighten the original screws that came with the holder through the mounting holes provided.

  • Reassemble the holder and install it on the bike.

Printing Recommendations

  • Nozzle: 0.4 mm

  • Layer: 0.16–0.20 mm

  • Infill: 80–100% (for maximum impact resistance)

  • Perimeters: At least 4

The downloads include two file types:

  • FreeCAD Document (.FCStd) — the original model. Allows you to make design changes if necessary.

  • 3MF file (prepared in Bambu Studio) — a print-ready file containing a customized print profile.

Tagi