Gridfinity holders for the Donau Elektronik Pin Vice + Drill Set
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Gridfinity holders for the Donau drill bit holder and its 2 sets of drill bits.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 32
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Share Alike
These are Gridfinity holders for the Donau Elektronik HSS250 set from T.M.E. (no affiliation), comprising of a pin vice and 2 sets of high-speed steel drill bits, 0,3mm-1,2mm and 1,3mm-2,5mm (2 bits of each size), in separate cases.
One holder stores is 1x2x6U and stores the pin vice vertically, while the other is 1x3x4U and stores the pin vice horizontally; the difference in holder height is to give a bit more support for the standing pin vice.
I'm using the horizontal one as the drawer is not high enough for a standing pin vice. To note that in the photographs, the prototype I printed for the vertical holder has a deeply-recessed cavity for the smaller set of drill bits; I went back to the 3MF and STL and raised the bottom of that by 1cm, so it should be easier to grab. Didn't waste plastic on a re-print, as I am not going to use that one.
Shamelessly-made with solid bins generated with PerplexingLabs' Gridfinity generator, which were then imported into Orca and sliced with negative parts sized and moved into the bins. The STLs are provided for those wishing to print the holder(s) directly and without fuss; the 3MF file is provided for those wishing to make changes to the holders in their slicers.
Straight-forward print, no supports are needed; I used a 0,4mm nozzle with a layer height of 0,24mm. Printed with Sunlu HSPLA Oreo.