Shower strainer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple strainer to keep hair out of the drain in our shower enclosure. Probably fits many kitchen sinks and…
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 58
- Wydruki
- 0
- Wyświetlenia
- 274
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A simple strainer to keep hair out of the drain in our shower enclosure. Probably fits many kitchen sinks and washbasins as well.
Optimized for high flow at low pressure.
Scale
At 100% scale, this thing fits drains with an inner diameter of between 38mm and ~46mm.
At 112% it fits standard 1¾ inch drains.
Print Settings
Printer:
Ultimaker Original+
Rafts:
No
Supports:
No
Resolution:
Any
Infill:
100% or thick perimeters
Filament:
Any PLA works fine
Notes:
No retractions needed if combing is enabled.
Print timeI printed mine in less than 15 minutes and it took ~2g of PLA (at 100% scale).
Category: Bathroom