Wii Remote and Wii Nunchuk Holders (Gridfinity)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Gridfinity system to store Wii Remotes and Wii Nunchuks
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 32
- Wydruki
- 0
- Wyświetlenia
- 216
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution — Noncommercial
Couldn't find a Gridfinity Wii Remote holder that worked for me, so I made my own. Inspired by alocon’s design but changed quite a bit. Went with two Wii Remotes per holder instead of one or four, felt like it made the most sense for flexibility. The prints showing four remotes were my first attempt, but splitting them up works better for configurability.
2 units wide, 4 units deep. (2 Wii Remotes)
Standard Gridfinity spacing for the base.
For the Nunchuk, it was by far the most difficult part. While this version is not perfect, it fits well inside a drawer without taking up too much space. I usually wind the cord first before sliding the Nunchuk onto the holder. It may feel a bit tedious at first to get everything to fit, but after a few attempts it became natural to me.
(I may make a different version in the future that's not as secure, but is easier to just drop the nunchuk into)
2 units wide, 4 units deep. (2 Nunchuks)
For printing, I used 10% cubic infill with 3 wall loops. Under normal use they should hold up without issues.