1 / 4
Custom-Fit Football / Soccer Shin Guards (Thermoformable) — zdjęcie 1
1 / 4

Custom-Fit Football / Soccer Shin Guards (Thermoformable)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Customizable football/soccer shin guards! Print flat, then perfectly shape them to your legs using warm water.

Ocena
0 / 5
Polubienia
16
Pobrania
102
Wydruki
0
Wyświetlenia
626
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Say goodbye to ill-fitting sports gear! These are lightweight, 3D-printable shin guards for football/soccer that you can custom-fit to your exact leg shape. The model prints completely flat, making it an easy and fast print. Afterwards, you use warm water to soften the plastic and mold it perfectly to your shins for maximum comfort.

Note: Currently, this file is for standard sizes. I will be uploading files for smaller shin guards soon! If you need a smaller size right away, feel free to leave a comment or send me a message.

Print Instructions

  • Material: PLA is highly recommended! It softens perfectly and easily in hot water (around 60°C / 140°F). PETG also works, but requires much hotter water (around 80°C / 175°F).

  • Supports: None required! Just print it flat on the build plate.

How to custom-fit your Shin Guards (Thermoforming)

  1. Prepare the water: Heat water in a wide pot or bowl. If you are using the recommended PLA, the water should be hot but not boiling (around 60-70°C / 140-160°F).

  2. Soften the print: Submerge the flat shin guard in the hot water for 15-30 seconds using tongs. Wait until it feels flexible.

  3. Protect your skin: Put on a thick long sports sock or use a towel over your leg to prevent any burns from the hot plastic!

  4. Mold it: Carefully take the soft plastic out of the water, shake off excess water, and press it firmly against your shin over the sock.

  5. Let it cool: Hold it in place for a minute or two until the plastic cools down and turns rigid again.

  6. Mistake? No problem! If the fit isn't quite right, just put it back into the hot water, let it soften, and try again.

Tagi