OpenWrt One wall/HSW mount

Made for the OpenWrt One.
The Banana Pi BPI-R64, BPI-R3, BPI-R4 have the same form factor and should be compatible as long as there is no lateral antenna. Alternatively, you can use the variants with lateral wall unfilled in order to let room for the lateral antennas. Make sure you can bridge over 39 mm. Can't insert the router with the antenna screws sticking out. Do not use this model for Banana Pis with antennas!
Banana Pis have not been tested with this model.

Remove/do not add the device feet.

how to print

The models can be mirrored to insert the power supply on the side of your choice.

3 models provided. The screw gaps have been calculated to match HSW's lattice.
• top insertion: device inserted from the top (recommended for a vertical wall mount)
• side insertion: device inserted from a side
• universal: holes for both options are included, so you can choose after printing

Print with the bottom on the build plate, as provided. No supports required.

Electronic devices can get quite warm. Do not print in PLA. PETG is advised.

how to use

Countersunk screws, M4 (base < ⌀4, top < ⌀8).

Attach it to the wall/HSW folling below instructions.

Then simply push the device in.

The device can be inserted from either end, and facing towards or away from the wall/HSW lattice.

wall mounting

Vertical mounting: use screws in the top holes. Screws in the bottom holes are optional.

Horizontal mounting: use screws in both holes.

HSW mounting

Follow instructions on the dedicated page.

links to components

(these are affiliate links, using them will cost you nothing, but will support my work)
(you can try and browse for other cheaper sellers, those are the ones i ordered from)

selftapping countersunk screws (M4 variants)
countersunk bolt screws (M4 variants)
OpenWrt One