Morrigan Gear Drive

I made this transmission to run the hobby wing fusion 1200 KV motor assembly is relatively simple if you’ve already done any of black crow's transmissions this one shouldn’t be all that different. I have not made in instructions yet but feel free to reach out if you need anything. I recommend filing a flat spot where the screw for each gear will land on the shaft and then use some blue Loctite on the screws.

5mm shafts 25mm, 22.5mm, 93.5mm and a 45 (this one needs drilled for the output shaft)

10 5x11x4 bearings (these are what the original transmission uses)

10-15 m5 washers (to shim gears with)

2 30T M1 gears https://amzn.to/4dsi7et

3 15T M1 5mm shaft gears https://amzn.to/4cczRZ2

1 15T M1 3.17mm shaft gears https://www.amainhobbies.com/hpi-mod-1-pinion-gear-3.17mm-bore-15t-hpi108267/p1537721?v=649474&utm_source=transactional_email&utm_medium=e-mail&utm_campaign=order_update&utm_cid=7387912&utm_content=%2fhpi-mod-1-pinion-gear-3.17mm-bore-15t-hpi108267%2fp649474

I do not recommend using a reducer sleave in a 5mm bore on the input gear as it does not sit cocc3ntric with the shaft one any of the ones I have tested and just generates a lot of heat.

Thanks to Black crow for sending me the files for the cheater transmission