Short stands for Bose Companion 5

I recently purchased a Bose companion 5 as a replacement for my logitech Z625 and noticed an inconvenience right away. With how wide my monitor is there is no good way to position them to not just fire into the back of the monitor, which is noticable in the sound. 

So I designed shorter ones with the same general look using most of the original hardware (except the neck part itsself ofc). I estimated the typical distance of a listener to 800mm and adjusted the tilt angle accordingly, even though it probably being completely overkill but when you are already designing a part you might just do it right. Medium was my first try which is about 9cm lower than the original, short is 11cm lower (comparison between original and the short in pictures). The later fit great under my 34" ultrawide and shoud work for 27" as well (same general height). Cable and plug can be fed through the neck like with the original stand. Installation just needs a screwdriver and about 15 minutes. 

Printed with 0,6 nozzle, 0,3 layerhight, 25% gyroid infill in extrudr NX2 matte PLA to match the estethics of the old stand (any matte black PLA will do)