1 / 2
Party Clip — Clip-On Wine Glass Holder for Cocktail Parties — zdjęcie 1
1 / 2

Party Clip — Clip-On Wine Glass Holder for Cocktail Parties

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Fit Party Clip to your plate, and free up your dominant hand by slotting your wineglass into it.

Ocena
5 / 5
Polubienia
5
Pobrania
21
Wydruki
1
Wyświetlenia
123
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Gadgets
Licencja
Creative Commons — Attribution

Introduction

Ever been at a standing reception, juggling a plate of finger food in one hand and a wine glass in the other — with no hand left for handshakes, napkins, or animated conversation?

Party Clip solves that problem.

This clip attaches to the rim of your plate and securely holds the stem of a wine glass, letting it hang neatly at the side. Your plate stays balanced, your drink stays within reach, and one hand is finally free — to snack, gesture, greet, or network.

Perfect for:

  • Standing receptions

  • Cocktail parties

  • Wine tastings

  • Conferences and networking events

  • Garden parties and buffets

Whether you're mingling, sampling hors d’oeuvres, or trying not to drop your canapé mid-conversation, Party Clip helps you enjoy the party with one hand free and one worry less.

Because good conversation shouldn't require three hands.

Model Options

The main model. which is quite universal, comes in a single file Party-clip.stl but there is a choice of options, too.

Different-angled Models

If you have a specific use in mind, the following options might come useful:

  • Clip with right opening: if you're sure you'll be putting your glass in the clip from that side

  • Clip with left opening: if you're sure you'll be putting your glass in the clip from that side

  • Clip for plates with less rised edges: the angle between the the plate clip and horizontal is only 15 degrees.

  • Clip for plates with more rised edges: the angle between the the plate clip and horizontal is 30 degrees.

Friction Pad

A 13-mm (½-inch) friction pad is a simple round pad that can be glued into the recess on the bottom of the clip.

Printing

The base model is best printed in durable, mostly inflexible material. PETG is great for this. The optional friction pad should be printed from something grippy, such as flexible TPE, or replaced with a store-bought rubber pad, 13 mm (½ inch) in diameter.

I find that printing the clip on its side is best, not only because the filament fibres run in the direction where you need greatest strength, but also because supports are easily generated and then removed from the finished product. Start from the attached 3mf slicer file to see what I did for supports.

Tagi