Airtag Mount (Underneath Seat) (Customizable)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A mostly hidden, compact way to store an Airtag on a bike. Designed for a mountain bike using a WTB Volt saddle.
- Ocena
- 4 / 5
- Polubienia
- 29
- Pobrania
- 145
- Wydruki
- 6
- Wyświetlenia
- 1000
- Oceny
- 5
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Share Alike
A mostly hidden, compact way to store an Airtag on a bike. Designed for a mountain bike using a WTB Volt saddle, however this should fit other seats as well. Most seats have the same sized rails, with the only difference being the angle between them. Requires 2 M3 nuts and 2 M3x12 screws. Hopefully this helps somebody keep their bike safe.
I used the “Add Modifier” (cylinder) tool in Prusaslicer, centered, 26mm diameter, set to 0 top/bottom layers in the middle. When combined with ~20-30% hexagonal infill, the result is a fine ‘mesh’ that lets sound and the bluetooth signal through easier. Testing showed the sound is easier to hear.
With the included .f3d file, you can make adjustments to fit your specific seat/saddle if this design doesn't fit. Adjust the angle in the very first sketch in the .f3d file to do this.
Note: This does NOT require the screws found on Specialized saddles, like other designs. This mounts directly to the rails, behind the seat post.