Adafruit 6V 6W or 9W Solar panel Mount and Rotating Base
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Edit 10/4/2021 - My requirements changed and so 6W is no longer enough. Updated the mount to also support the 9W solar…
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 76
- Wydruki
- 0
- Wyświetlenia
- 852
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
Edit 10/4/2021 - My requirements changed and so 6W is no longer enough. Updated the mount to also support the 9W solar panel.
Designed for use with the Adafruit 6W "huge" solar panel and 9W "colassal" solar panel https://www.adafruit.com/product/1525 https://www.adafruit.com/product/2747
You will need:
1x "Huge" 6w solar panel or "Colossal" 9w solar panel
4x m3 bolts (8mm should do, 10mm would be too long)
1x m8 bolt (30mm - washers are a good idea)
1x m8 nut (wingnut recommended)
4x mounting screws <=10mm diameter and at least 10mm long (in my case wood screws and washers)
To Print (6W panel):
RotatorBottom
RotatorTop
PanelMount6W
To Print (9W panel):
RotatorBottom
RotatorTop
PanelMount9W_L (x2)
PanelMount9W_R (x2)
Keep in mind you may not need those exact sizes. I designed with a bit of wiggle room and if that's not enough the freecad file is included and parameterized.
I used these documents for dimensions on the solar panel.
Print Settings
Printer Brand:
Creality
Printer:
Ender 5
Rafts:
No
Supports:
Doesn't Matter
Resolution:
200
Infill:
20
Filament:
PolyMaker PLA
Notes:
Maybe print in ABS if it will be outside and you don't want to replace it when it breaks down. However, the solar panel has a bigger footprint than the mount, so it should be mostly protected from the sun...
Category: Electronics