Cube Cubie 160 Balance Bike
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Converting a Cube Cubie 160 childs bike into a balance bike
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 47
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Vehicles
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Our daughter got a Cube Cubie 160, but is not comfortable with pedals yet. To use it currently as balance bike, some protective covers and a holder for the chain had to be made.
I also created covers for the rear and front wheel nuts to have a consistent look.
What do you need?
2x FrontWheel
2x RearWheel
2x Pedal-L1
1x Pedal-L2 or Pedal-L2-slim
1x Pedal-R or Pedal-R-slim
I created a slim version for the end parts on both pedal sides, because our daughter liked it more. The normal versions were too big for her and hindered when driving.
Because it will be used outdoors, I advise against the usgae of PLA. I used PETG. ABS or ASA are also valid options.
Assembly:
For the wheels, just remove the nut and washer an add the respective part on the threaded rod and but the washer and nut into the cover and fasten it again.
For the pedals removing a crank puller is needed. The chain cannot be removed without opening it. Because of the extra cover around the chain I instead designed a holder for it.
The 2x L1 part can be pressed together and put on the drive shaft on the left side where the chain is. If they are to snug for the chain, you can reduce the outer size, therefore the step files.
then finish it with L2 part (slim or normal) and fasten it.
same on the right side just with the R (-slim) model
Happy driving!