Broadway Playbill Frame - sturdy remix for large grids
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Sturdy modular grid remix. Features sturdy vertical and 4-way connectors.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 73
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Wall-mounted
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a snap-fit 2-part frame designed for hanging theater playbills. It is sized for NY Broadway playbills, taking into account small variations.
The backplate is designed and tested to snap fit into the frame without any scale adjustments. There are holes in the backplate designed to accept the side clip and four-way connector to create a rigid grid of frames. I hung three 4x4 grids, with horizontal spacing of 1 frame. For alignment, I temporarily assembled a 14x4 grid to mark all drill holes at once before mounting.
The design was tested using 3 perimeters and 0.2mm layer heights, infill percentage is not crucial, 10-15% is enough.
To assemble the frame first place the frame face down. Place the playbill into the opening on the back (optionally cover the playbill with a PVC cover cut to size). Then press the backplate into place until it clicks in all 3 locations on each side. There are 2 hanging points in the backplate (as in the original design). I used the upper hanging points of the top corner frames only. Two screws at the corners are sufficient to securely hang a 4x4 grid.