Self-Bow Limb Thickness Marking Gauge
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Tired of being frustrated when marking your self-bow limb thickness? This is the model for you.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 37
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
I designed this model after being frustrated every time I would mark self bow limb thickness on a stave with crown.
It prints best in PLA due to the significant overhangs but it got by with PETG as well so shooters preference depending on the quality you are after.
One thumb screw is shorter to hold the pencil block in place and one is longer to hold the pencil in place. It also requires to m3 heat inserts in the side of the pencil block as well. Below is the hardware that I used as well as the level bubble that glues into the top with superglue.
Both files should be in optimal orientation, no supports no adhesion.
Level Bubble: https://amzn.to/3Orja49
M3 Thumb Screws: https://amzn.to/3Qg0W69
M3 Heat Inserts: https://amzn.to/4t3KsNa
**Disclaimer: These are amazon affiliate links, if you make this model and feel like supporting me, it is greatly appreciated.