Eureka Mignon Bellows - Hollow & Air hole
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a remix of the remix from user 'Tyler_3D_Prints' of the bellows attachment for the Eureka Mignon Single…
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 111
- Wydruki
- 0
- Wyświetlenia
- 782
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution
This is just a remix of the remix from user 'Tyler_3D_Prints' on ‘Thingiverse’ of the bellows attachment for the Eureka Mignon Single Dose mod from user "rmanalan".
I made the 'roof' slightly thinner (+/- - 50%) as it was unnecessary thick, as well as added an air hole in the roof. The air hole will be closed when you push the bellow down with you flat hand, and if you lift your hand quickly again after, the bellow will suck some of the air needed for inflation trough the hole, meaning less ground coffee will be sucked back up the wrong way.
For some reason the original 3D file creates a lot of weird artifacts/ a weird path in the slicer, which can be mitigated if printed in vase mode. Naturally, the bellows need to be printed in flexible filament (e.g., TPU).
Category: Kitchen & Dining