Ambrogio L15/Twenty Rubber wheel
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Multi-piece wheel replacement with comparably cheap RC beadlock rubber tires
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 107
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
UPDATE 2026-04-23: after a few weeks of mowing they are keeping up very well and have actually pretty good grip. Maybe even better than the original ones. And they have especially enough grip to ensure proper contact to the docking station to not cause charge interuptions that i experienced with the old original ones.
I had to replace my original ambrogio wheels for my L15 and only found them pretty expensive online, so i tried it this route. Was a fun project and so far they are keepoing up quite well and have good traction.
The optics of the robot now reminds my a bit of the batman tumbler with the large twin tires.
Printed in ASA CF with a 0,6mm nozzle and 0,3mm layerheight.
Necessary parts:
Injora 1.9" Swamp Claw S5 tires (4pcs ~30€)
16x M3x35 SHCS bolts
16x M3x5,7mm heat set insert
I tried to keep supports to a minimum, but the two overhanging beads to lock the tires in place need some, as well as the center of the outer most rim part. Red highlighted faces in the Screenshots show the areas where i put support during printing.
The tires are RC bead lock tires, so they are clamped in between the parts (except the most inside portion of the inner tire --> see Screenshot).