Gravel Nozzle For Vacuum (Vax in STL, adaptable to others via F3D) To Clean Leaf Litter From Stones
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Avoid vacuuming up your stones but get rid of leaf mess
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 54
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I have a bonsai area in the garden with white chippings size 10mm+ that get messy with small leaves and other debris.
Normal vacuum nozzles just suck up the stones even if I set the Vax to minimum and open the tube vent, so I had to find a way to clean up the stones without losing a load of them into the vacuum bag!
I made this somewhat parametric (for the accessory's nozzle ID, wall thickness, length to slip over the vacuum tube, length of the conical section, and the diameter of the stub tip) so if you want to adapt it to a different machine then try fiddling with FX Parameters in the enclosed F3D in Fusion. I haven't experimented with how far you can tweak it before things go wrong, hehehe, just have a go. If you have a Vax (pipe OD and therefore nozzle ID = 31.75mm) then the STL enclosed will do the trick.
I used PLA+, 0.4mm nozzle, 0,2mm layers, no support or adhesion, everything normal PLA settings except I upped the number of perimeters to 4 so it's basically all walls.
It did a fine job for me, I hope it does for you too! Small debris will get sucked up, larger stuff will just get caught on the nozzle so you can grab it with your hand and drop it in a bucket where you can separate any stones that have got caught too and return them to the ground. Certainly beats the hell out of kneeling down and picking all the bits out with your fingers anyway :o)
Please Like this model if you find it useful.
If you REALLY like it, https://www.buymeacoffee.com/gigabeast :o)