Cable covers/managers for Rook MK2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Various cable manager pieces for Rook MK2 that use the extra m3 heatset holes in the frame.
- Ocena
- 5 / 5
- Polubienia
- 2
- Pobrania
- 7
- Wydruki
- 1
- Wyświetlenia
- 47
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
These are some cable manager parts I have made to help keep wires under control on my Rook MK2. All of these are made to fit on the extra m3 heatset screw holes that Rolohaun and Kanrog added to the frame. They are all made with pocketed holes for a pair socket cap m3x6 screws.
Rook-MK2 Umbilical Clip - Mounts Vertically on the Top and Mid Frame sections, intended to go on either side of the PTFE tube holder to keep toolhead wires from flopping around. Has a 10mm square channel with rounded edges.
Rook-MK2 Rear Rail Cable Cover - Mounts on the two holes on the bottom rear frame next to the stepper. has a roughly 8mm square channel under the frame body. I use it to hold the stepper lead and the wires that go from my switch socket to the power supply mounted on the back plate.
Rook-MK2 Cable Channel - I have not actually used this one, but I did test fit it. This one matches the width of the frame rails and has two 5x8mm channels. It seemed like it was going to be a great idea, but I never found a use for it in my setup.