Ender3 (235x235 bed) Leveling/Z-Offset Test Print
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple test print for levelling/z-offset correction.
- Ocena
- 0 / 5
- Polubienia
- 21
- Pobrania
- 851
- Wydruki
- 2
- Wyświetlenia
- 2045
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Test Models
- Licencja
- Creative Commons — Public Domain
A simple test print that should cover the bed with small squares. Each square is only 1 layer (at .2 mm) thick.
I use this model to adjust my z-offset to just the right value - it's really nice to see uniform, clean, smooth squares.
Print without a skirt, brim, raft, or anything.
Squares should come out solid with a clean top. If the top isn't clean (but the squares are solid), then you're probably a tiny bit too close to the bed (increase your z-offset (i.e. make it less negative)). If the squares don't stick or are not solid (come apart when you pull on them), then you're a tiny bit too far away from the bed (make your z-offset more negative).