rigidbot e3dv6 zeroloss cooling fan
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Use this with sactocal's lossless e3d setups -- it replaces the forward left stand, and provides enough clearance that…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 103
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
Use this with sactocal's lossless e3d setups -- it replaces the forward left stand, and provides enough clearance that the cooling fan won't drag on the bed (unless your printer is globbing badly).
Print Settings
Printer:
Rigidbot
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0.2
Infill:
25%
Filament:
inventapart PLA
white
Notes:
I used some old PLA I had lying around, but this should probably be done in something higher temperature (PETG or ABS), because if the nozzle gets too close to your hotend, you'll experience some drooping.
Update: I'm a year into using this setup, and i adore it. It's simple, and it works so well, i haven't even bothered to reprint it in a better filament. Parts cooling is good, and i have only one minor complaint: Periodically, you may wish to ensure the cooling fan is firmly in place on the cooling duct. It likes to vibrate out a little.And yes, I need to shorten those wires. It's on the list.
Category: 3D Printer Parts