Antistabic Joystick 4 SeedSigner
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is an EXPERIMENTAL screw Joystick for the Waveshare Display Hat. Use at your own risk.
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 70
- Wydruki
- 0
- Wyświetlenia
- 868
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other 3D Objects for Learning
- Licencja
- Creative Commons — Attribution
This is an experimental threaded Joystick for the nub of the waveshare display hat used in the SeedSigner.
How to print:
Print with the thread facing down, about 3 mm above the build plate with light supports. Use the finest layer height your printer is capable of. You might have to play around with scaling between 100 and 105 % to account for resin shrinkage.
How to install:
First, the joystick must be pressed firmly
on the „nub“ but still gentle enough
so as not to break the click function.
Then it sits on it loosely, now screw it on the nub about half
a turn, with a bit of force, while pressing down. Remember that you're trying to thread onto a square shape, so you'll have to guide it.
The resin is harder than the plastic and should thread
itself into the nub. Don’t overturn or you
will break off the nub.