TF2 Logo Keychain
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a TF2 logo keychain based on the r/place logo created on Reddit. To get the multi colour I used the 'Change…
- Ocena
- 0 / 5
- Polubienia
- 25
- Pobrania
- 104
- Wydruki
- 1
- Wyświetlenia
- 765
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- 2D Plates & Logos
- Licencja
- Creative Commons — Attribution — Share Alike
This is a TF2 logo keychain based on the r/place logo created on Reddit.
To get the multi colour I used the 'Change Filament at Z' Cura plugin. (https://www.thingiverse.com/thing:2077884)
My printer settings were 0.2mm layer height, 0.24mm layer width.
The layer count used to change filament is as follows:
0 - Black
6 - White
8 - White
10 - Orange
13 - Yellow
16 - White
You can check and use different layers in your slicer and update the colors accordingly.
Use infill greater than 40% to get good surface finish.
Feel free to use this however please give proper credit.
How I Designed This
Traced out the image in Fusion 360 and then extruded each part accordingly. svg of this image was not proper hence had to trace all the shapes.
Category: Signs & Logos