Easy and fast shrinking Test for Z
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Aparently Z shrinkage is different to X and Y . This is a very fast, easy to print tower for 4g of filament.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 29
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Test Models
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The STL is designed wit a big surface for better bed adhesion in mind, so that bed slingers can print them fast without having to worry that it would tip over. Ad the same time you dont need much filament and it can be printed completely hollow.
For a fixed Bed I scale X and Y down to 25% and leave Z at 100% . This gives you the ability to print it in a few minutes and only use 4g of filament.
Go to orca Slicer and set your Z-shrinkage to 100%
if necessery scale the model down like mentionen above
Print the File
VERY IMPORTANT! Let the printed part cool down so that it does not shrink anymore.
Messure like in the picture
Put the mesured value in the filament shrinkage location (for example 99,73%)
Done