BOSS Ring from Alice in Borderland
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a replica of the ring seen in Alice and Borderland
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 117
- Wydruki
- 0
- Wyświetlenia
- 1262
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Cosplay & Costumes in general
- Licencja
- Creative Commons — Public Domain
This ring fits a US ring size 8.5, which is 18.6mm in diameter. Scale appropriately.
Print Instructions
Supports
You can print this in a couple of orientations. If you print as-is, with “BOSS” facing upwards, you'll want supports on the inside of the ring and also supporting the upward curl from the bed. These supports are easiest to clean, but can be scratchy on your finger without careful sanding.
Alternatively, position the ring on its side. You'll want some supports under the “BOSS” plating on the front and also between the ring and the bed. It's a little tricky to remove the supports, but requires the least sanding afterwards.
Infill
It doesn't really matter because the ring is so thin, it'll mostly be filled with perimeter walls anyway, but the more infill, the better.
Layer Height
0.1, preferably. The wavy detail under “BOSS” is pretty hard to see any higher than 0.1 layer height.