1 / 8
Screw-In Filament Clip - Robust Design - 1.75mm - 1 Gram Print - Filament Holder
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A new take on a filament clip where the clip is attached to the spool with screws
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 32
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
A new filament clip design. Rather than clipping on to the side of the spool, this clip is held on by two M3 screws. Highly recommended to print with .08 layer height for hole accuracy. Instalation:
Using the printed clip as a template, drill 2 holes in the side of the spool near the top with a 7/64" bit.