Ergonomic Mortise Style Lock Holder for Locksport
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I made this ball model for holding my mortise locks while practice picking.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 60
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I made this model after seeing Sparrow's "The Sphere".
Print it as it is oriented. You might have to flip the cap model to print it flat on the bed. I recommend using fuzzy skin as it feels better in the hand than just layer lines. The cap is friction fit, so you might have to work with tolerances a bit, but the cap prints in ~ 6 minutes.
Designed in Onshape.
UPDATE:
Renamed the original ball to v1 and added v2. V2 makes the cylinder in the middle deeper and makes the lip on the front wider to accommodate locks with larger face plates. V1 was designed with the Covert Instruments practice lock measurements. V2 was created using measurements from both a Yale and a Sargent mortise lock which V2 fits much better. If you're only using the CI practice lock, V1 is fine. For everything else, I'd recommend v2. The faceplate hasn't changed and is compatible with both versions.