1 / 1
Sigma ROX 4 quater turn mount male repair - No supports — zdjęcie 1

Sigma ROX 4 quater turn mount male repair - No supports

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Repair module for Sigma Rox Bike computer to glue on. Tested with ROX 4.0 but should be compatible to other ROX

Ocena
0 / 5
Polubienia
1
Pobrania
29
Wydruki
0
Wyświetlenia
150
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This repair module for the Sigma ROX bike computer can be glued onto the device if the tabs of the quarter-turn mount are broken. Tested with Sigma ROX 4, but should be compatible with ROX 2,7,11,12. Please comment if you have tested it with another model.

It was inspired by the Garmin quarter-turn mount by two_d_man (https://www.thingiverse.com/thing:6674804), but has been completely redesigned. The original version does not properly snap into Sigma holders, which required a new approach.

This version fits both the original Sigma holder and my custom replacement holder (see my other models).

I printed mine in ASA to ensure higher strength than the mount itself, but PETG also works well. I used contact adhesive (e.g., Pattex), which provides a strong bond while still allowing removal with tools if needed.

Version 2:

  • Improved snap-in mechanism for both original and custom holders

  • Added a hole to keep the ROX 4.0 sensors unobstructed

  • Important: Test the snap-in fit with your holder before gluing

Version 1:

  • Initial version, less refined than Version 2

Additionally, I included a standalone quarter-turn mount model for remixing.

The model can be printed without supports.

Tagi