NuppiNode - Meshtastic/Meshcore flagpole cap radio enclosure
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
65mm flagpole cap radio equipment enclosure with N female bulkhead connector base and zip-tie perforated plates
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 199
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a replacement flagpole cap for typical Finnish 65mm flag poles.
I used 25x25mm N female bulkhead connector to connect 5.5dbi antenna:
https://www.aliexpress.com/item/1005008984322302.html
Rough schematic for my setup:
12V lead gel battery --> 2A fuse --> 12V to 3.3V step-down module (adjustable) --> heltec v3 with Meshtastic firmware --> cheap saw filter --> bulkhead n type female connector --> 5.5dbi antenna. Ask for details if needed. Remember to use a fuse when dealing with 12V batteries, also tie all the stuff down with zip ties, wind will shake everything so you don't want a short up in your flagpole.
Print the enclosure with ASA/PETG or some else filament that endures UV rays. When attaching the top to bottom, use some glue that can withstand UV radiation also.
Improvement ideas:
modify the bottom part to be freely rotating, also considering the 12V wiring. Freely rotating enclosure would help the actual purpose of a flagpole - letting the flag fly freely.
press-to-open latches for the top part to lock in place instead of using glue for securing the top to bottom.