Plymouth Prowler A-Arm Ball Joint Cap Replica
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a piece I recreated from the measurement of an authentic piece, in OnShape.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 38
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a A-Arm ball joint cap piece meant to socket on to part of a (1997-2002) Plymouth (or Chrysler) Prowler A-Arm.
It has been tested on a 2002 Chrysler Prowler (After Plymouth went out, Chrysler sold it under their brand, but it's a Plymouth Prowler besides branding differences) and should socket on just like the authentic piece.
For best results, print with the Prowler logo facing up and use your preferred support type, but I recommend using the Tree/Organic supports.
To make the piece look less like a 3D print, you can sand down the main Prowler logo slightly so it rises above the surface about 1mm tall along the slant (the top is meant to replicate the subtle slant on the top surface of the original piece), and maybe add a clear coat of some type to smoothen out the appearance.