Electrical Toothbrush and Shaver Holder with Storage

Our family uses Electrical Toothbrushes. A disadvantage is that it can relatively easy be tipped over by accident when standing in the charger. And there is almost always some residues of toothpaste water that runs down from the brush on the charger. And further down on the cabinet when it runs over the edge of the charger, resulting in soiling and potentially water damages on the cabinet surface. The cable to the charger is also in the way a lot of the time and gets tangled.

I also had my Electrical shaver lying on the same Bathroom cabinet shelf. Leaving small hairs from shaving in the cabinet when lying it down. Which was not very appreciated by my wife. 

So I made a combined holder for the Toothbrush and Shaver. It consists of a bottom plate where the Toothbrush charger can be snapped into place. It also has two small storage containers, where replacement brushes and the cable can be stored. The containers are also placed so the cable to the charger is fixed between them. The charger is put in place by placing one edge first against the holder "wings" and then pressing the other edge down until it snaps into place against the other "wing".

The Shaver is put into a rectangular tube stand that has inner measures 35x44 mm. Adapted to my Braun shaver with some margin, hopefully it fits more shaver handles. The tube holder has a slot in the back and a cut-out in the bottom. So the charger cable can be connected to the shaver and be charged while standing in the holder. 

I printed this in White Buddy3D PLA with a 0,6 mm Nozzle on my Flashforge Adventurer 4.