1 / 5
Enclosure for a 100W power bank, 5S3P configuration with 18650 batteries.
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is an enclosure for a power bank with 18650 batteries, 5S3P configuration, based on a 100W board.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 27
- Wydruki
- 0
- Wyświetlenia
- 151
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Power bank enclosure for 18650 batteries, designed for a 100W board. The front and back parts are recommended to be printed in PLA, while the top and bottom parts should be made from PETG. The display is desoldered from the board, then reconnected using wires and glued to the front part of the enclosure. M3 threaded inserts are installed inside. A total of eight screws and eight inserts are used to fasten the front and back panels.
