Beko / Arctic Freezer Drawer Transparent Wall Replacement Blocks (Claw Fix)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The front, transparent wall of the freezer was broken, so here is the solution
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 66
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution
These black blocks are a direct replacement for the fragile original plastic claws that hold the transparent front wall on Beko and Arctic freezer drawers.
When the original claws break (very common problem), the whole front panel falls off and the drawer becomes unusable. This simple but strong design solves it permanently.
Each block has two perpendicular holes:
Front hole → screw goes through the transparent wall for a perfectly flush finish.
Side hole (90°) → screw fixes the block firmly to the drawer body.
Print recommendations
Material: PETG (excellent choice – strong, slightly flexible, stays tough in freezing temperatures and humid conditions)
No supports needed
0.2 mm layer height, 4 walls, 30–40 % infill for maximum strength
Print in black for the best visual match to the original drawer
Installation is very simple:
Position the block where the old claw was.
Screw it into the side of the drawer.
Screw the transparent wall into the front hole.
One set contains 2 blocks (left + right).
Saves you from buying a whole new drawer or expensive original spare parts. Works on most Beko and Arctic freezer models that use this clip system.
Printed and tested in PETG – proven to survive years in the freezer without becoming brittle.
Enjoy your drawer working like new again!