Magnetic Wall Mount for TRMNL 7.5inch(OG) DIY Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Magnetic adapter plate for @FliesWithWind's TRMNL case to be mounted via adhesive strips
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 350
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
Idea
After having printed @FliesWithWind's beautiful DIY TRMNL enclosure and with good success on my whiteboard, I wanted another mounting option.
The requirements were:
Easily removable device for charging or relocating
Mountable via adhesive strips
Clean design
Design
I opted for a magnetic mount but used smaller magnets (10x2 mm) than in the original case. I initially added a peg to be used with the wall hanger case variant, but after testing I didn't find that necessary. The measurements were derived from the original model.
The mounting plate is quite a bit smaller than the device, just enough to house the magnets.
Printing
Straightforward, standard settings.
Assembly
Insert 4 magnets (10x2 mm each) into the back of the panel, make sure their polarity aligns with the ones in the device. If necessary, use a bit of epoxy to secure them. Mount the holder to the wall with command strips.
Of course you will ned the original case with magnets in the back. Thanks again to @FliesWithWind