Prusa XL camera mount ESP32cam
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
ESP32cam camera mount with housing for the left side of the Prusa XL printer.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 86
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
ESP32cam camera mount with housing for the left side of the Prusa XL printer.
It is best to solder the power supply leads for the ESP32cam camera to the 5V and GND pins.
The camera gets quite hot, and you can stick a Raspberry Pi heatsink onto the processor.
Note: The camera is powered by 5V. I used an LM7805 with a large heatsink and connected it directly to one of the power supplies on the back of the printer (24V). You can also use a 24V to 5V step-down converter.
The method of programming and configuring the camera is available here: Release 1.1.2 Firmware for Ai-Thinker ESP32-cam, ESP32-S3-EYE 2.2, Freenove ESP32-Wrover, Freenove ESP32-S3 Wroom, XIAO ESP32-S3 Sense, ESP32-S3-CAM · prusa3d/Prusa-Firmware-ESP32-Cam · GitHub
Due to the temperature, it is best to print with PET-G.
To assemble, you'll need:
- 2x M4x5-8mm screws,
- 1x M5 8mm screw,
- 2x M5 10mm screws,