Sony MZ-RH1 Minidisc Sidecar Battery
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The last SONY minidisc player did not have an external battery, this print SUPERSIZES the sidecar for 150 hours runtime
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 37
- Wydruki
- 1
- Wyświetlenia
- 292
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Features:
1) Provides up to 150 hours of runtime, uses a 18650 battery with 10x the capacity of the internal battery.
2) 'Latches' into the RH1 using the battery door. There are hollow spaces in the door that catch the sidecar; you should feel a slight bump upon insertion/removal
3) The holes on the endcaps allow me to use an external (Olight USB NiMH/LION battery) charger with 4mm magnets to reach the terminals. The Olight is fast, and the internal charger appears to work, but I haven't tested it enough to know its performance characteristics (i.e is it fast or slow.)
4) There is space for a rubber band to catch the back of the sidecar for extra attachment security.
Print Details:
Print with supports and use the finest layer height possible. You'll use it all the time, so it should be beautiful. Manually adjust supports to catch the two battery door latches and the curved wings. Use 4 perimeters (if using a .4mm nozzle for a solid print.
Assembly Notes:
Once printed, route solid-core wires through the holes and solder one for the terminals; the two for inside the MZ-RH1 (or M200) are roughly 3x8, bent at 90, with 3mm on the short side. The terminals in the battery caps should be 6mm x 10mm, such that the hole is fully covered. Melt contacts in the plastic to keep them in place. Super glue end caps into place (verify battery polarity first). Use a clamp to ensure a TIGHT fit.