iPhone 14 pro case with 3 card wallet compartment

This case adds a 3 card compartment to the back of your iPhone 14 pro.  The case is thick enough to make the back of the phone flat and protect the camera bump.  The case is thin enough to allow wireless charging even when there are cards in the compartment.  The three pieces of this model slot together securely without glue. 

Benefits

• Protects the camera bump out

• Allows phone to lay flat on its back

• Securely holds up to 3 credit card sized cards

• No glue is required for assembly

• Phone case, card keeper and card keeper door pieces are easy to assemble and disassemble so you can change them often to match outfits, holidays or whatever

• Fast printing.  Phone case takes about an hour.  Card keeper and card keeper door take about 25 minutes each

• You can wirelessly charge your phone through the case and cards

Drawbacks

• Not compatible with MagSafe charger or accessories

Printing instructions

Case

Material: TPU

Infill: 20%

Supports: Yes.  I put a support blocker on the pin hole.  See the attached images.

Orientation: Lay the flat back of the case on the build plate.  Use the orientation given in the model file.

Card Keeper

Material: PETG.  PLA might be ok, but I'd be worried it might crack at the hinge connection

Infill: 20%

Supports: None

Orientation: Lay the flat back of the card keeper on the build plate.  Use the orientation given in the model file.

Card Keeper Door

Material: PETG.  PLA might be ok, but I'd be worried it might crack at the hinge.

Infill: 20%

Supports: Supports only needed for the hinge pin overhangs.

Orientation: Lay the flat back of the card keeper door on the build plate.  Use the orientation given in the model file.

Assembly

The top of the card keeper has the walls and a peg sticking out out of it.  The bottom of the card keeper is the other side and is completely flat.

The top of the card keeper door is completely flat.  The bottom of the door it the other side and has a hinge on one end and a lip on the other.

To assemble the card keeper and card keeper door, insert the lip edge of the card keeper door all the way through the slot in the bottom of the card keeper.  Use a screw driver or something hard to click the door hinge pins into the corresponding slots on the card keeper.  It should now be possible close and open the door.  The door opens to a bit less than a 90 degree angle.

Then side the card keeper assembly into the cutout in the case making sure to press the card keeper pin into the corresponding hole in the case.