Fully Articulated Wall-E
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a fully articulated model of the Pixar Character Wall-E
- Ocena
- 0 / 5
- Polubienia
- 16
- Pobrania
- 45
- Wydruki
- 0
- Wyświetlenia
- 255
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Action Figures & Statues
- Licencja
- Creative Commons — Attribution — Share Alike
This is a fully articulated model of Wall-E. It features openable doors (both back and front) arms that are articulated as well as on a rail so it can move, and fully working tracks on the feet.
REMEMBER TO PRINT IN PETG, PLA WON'T LAST LONG WITH ALL THE JOINTS OF THIS MODEL
Instructions
Head- Snap in the eyes into the connecting piece, than connect the 2 ball joint pieces together and snap it onto the eye connecting piece and top plate.
Front- Insert the door handle into the door, than add in the triangular pieces into the oles on the handle. Than, push the door into the front plate (You can see the holes where they go) and close the door making sure the triangle pieces go through the holes on the plate
Back- Similar to the front, just snap the door into the plate
Arms- Insert the ball joint with a thread onto the rail, than screw the ball joint on with the nut. The fingers just snap into each other (The raised part on the first section of the finger is meant for connecting to the hand) and onto the hand. All you have to do from there is connect all the ball joints together
Body- Once you completed the plate pieces, you can connect the body parts together. You have to connect the front piece with the top, than add the back piece, than the bottom piece, and finally push the arm plates into either side (Make sure the long side of the rail is at the front)
Feet- Slide the gears onto the board, than use the nuts to screw them on (Be aware that the right pieces turn counterclockwise to tighten). For the tracks,you can just snap each piece together to make the full track. You won't need all the track pieces though, so don't be too worried if a couple break. Finally, stick the slot on the foot board into the threads on either side of the arm and you're done! (The right nuts also tighten counterclockwise here too)
Printing
Only part that needs supports is the top plate, for the eyes and eye connecter
You need 2 pairs of tracks
The entire project is in the downloads, and the plates are fine to print as-is
